Home Access Atlas

Harmar Pinnacle: what the light and the beeps mean

Harmar does not use a numeric display. Your lift tells you what is wrong with the colour of the armrest light and the number of beeps. Start with the colour.

Last verified

Start with the light

The LED on the armrest is the first diagnostic, and on a Pinnacle it carries more information than most owners realise.

Armrest LED
LightMeaningWhat to do
GreenNormal. It will drive in either directionNothing
AmberTouching an obstruction. It will only drive away from itDrive away from the obstruction, then clear it
Flashing amber, with an intermittent beep for 30 seconds repeating every 5 minutesStopped away from the charge strip, so it is not chargingMove it to a charge station at either end of the rail
RedA problem that may need a service callSwitch the lift off and on again. If it stays red, call your dealer and describe it

Amber is the one people misread as a breakdown. The lift is doing exactly what it is designed to do, and it has deliberately kept the one direction that gets you off the obstruction.

Major faults: count the beeps

If it will not run at all, count how many beeps it gives. Harmar numbers eight conditions.

Beep count
BeepsCondition
1Runaway
2No power
3Footrest up and footrest down switches conflicting
4Obstruction up and obstruction down conflicting
5Footrest down and obstruction up conflicting
6Footrest up and obstruction down conflicting
7Stop up and stop down both detected
8Stop up and stop down both not detected

Six of the eight are a pair of switches disagreeing with each other. That normally means a switch, a sensor or its wiring has failed rather than anything the owner can put right, so counting the beeps is mostly about telling the technician what to bring.

Minor faults: one long beep

A single long beep is a minor fault, and it clears itself once the cause is gone. Harmar lists five:

Turn the seat square, clear the stairs, check the footrest is down and the charger is plugged in, and a single long beep usually goes away on its own.

The power swivel fuse that looks like a breakdown

Two situations worth knowing, because both get misdiagnosed.

The lift stops when the seat is not at a landing. Do not stand up. The power swivel has a recovery mode: let go of the controls, then press down on the armrest control. The seat rotates back to its home position and the lift moves down.

The seat starts and stops while rotating. The electronics are protected by a self resetting fuse that trips if the seat runs against a stop for more than about five seconds. It needs roughly two minutes to reset. Wait it out before assuming the swivel motor has failed, because an owner who keeps pressing the button will keep re-tripping it.

Power footrest not operating

Harmar's guidance is to confirm the four pin footrest control cable is plugged into the chassis, then contact the dealer. They are explicit that the lift should not be used if the footrest does not fully lower.

Getting someone off a stopped lift

Harmar documents a manual override for a failure where the rider cannot get off on the stairs. It uses a quarter inch socket and wrench, or a 7mm depending on the model, to turn the motor shaft through an access hole in the lower safety flap, with the lift's on/off switch in the off position.

The instructions are printed on the safety flap itself and in the owner's manual. Read them there rather than working from this page: this is a person suspended on a staircase, and the order of operations matters.

Who services a Harmar

Harmar's manual directs owners to their dealer, and the dealer network is where parts come from. If the original installer has closed, the question becomes which local companies service Harmar units they did not sell. Providers almost never publish that, so ask before booking a visit. Our directory shows which providers install Harmar, and those are the likeliest to carry the parts.

If you are weighing a repair quote against replacement, see what a stair lift costs. Owners of other brands may want the Acorn display code guide, which works completely differently.

Light behaviour, beep counts and fault lists above are taken from Harmar's Pinnacle SL600 owner's manual, section 5, and reworded here. Checked on the date shown. Other Harmar models, including the SL600HD, have their own manuals, so confirm against the document for your unit.