Wheelchair ramp slope and length calculator
Measure the rise, the vertical distance from the ground to the doorway, and this works out the ramp length, whether you need a landing, and how much room the whole thing takes up.
Last verified
Ground to the top of the doorsill, in inches. Three steps is usually 18 to 24 inches.
A single run works A rise of 24 inches is under the 30 inch limit, so one continuous run is allowed. You still need a level landing at the top and bottom.
| Slope | Use | Length needed |
|---|---|---|
| 1:12 | ADA standard, unassisted | 24 ft |
| 2:12 | Assisted, someone pushing | 12 ft |
| 3:12 | Unoccupied only, loading an empty chair | 8 ft |
| Ramp runs | 1 run |
| Intermediate landings | None needed |
| Total length including landings | 34 ft including top and bottom landings |
This calls for a modular ramp
Beyond about ten feet, portable ramps stop being practical to move or store. Modular aluminum sections bolt together, need no concrete, and can be taken apart and resold later.
Check the slope of a ramp you already have
Already have a ramp, or a quote for one? Enter its rise and its length to see the slope as a ratio, a percent grade and an angle, and whether it meets the ADA 1:12 maximum.
Vertical height the ramp climbs, in inches.
Length of the sloped surface, not counting flat landings, in feet.
1:8, steeper than the ADA allows Grade of 12.5 percent, angle of 7.1 degrees. At 1:12 this rise needs 18 ft of ramp.
| Slope | Percent grade | Angle | Typical use |
|---|---|---|---|
| 1:20 | 5% | 2.9° | Gentlest; ADA treats anything this shallow as a walkway, not a ramp |
| 1:16 | 6.25% | 3.6° | Easier to climb; some installers suggest it outdoors |
| 1:12 | 8.33% | 4.8° | ADA maximum for a ramp a person climbs unassisted |
| 2:12 (1:6) | 16.7% | 9.5° | Assisted only, someone pushing |
| 3:12 (1:4) | 25% | 14° | Loading an empty chair or scooter |
How to measure the rise
Almost every wrong answer starts here. The rise is measured from the ground where the ramp will land up to the top of the threshold you are trying to reach, not to the bottom of the door and not to the top step.
Rest one end of a long level or a straight board on the doorsill so it sits flat, then measure straight down from the underside of the board to the ground. Measure where the ramp will actually sit, since driveways and paths often slope away from the house. If the ground falls away by more than an inch or two across that distance, use the lower measurement.
What the 1:12 slope actually means
A 1:12 slope means one inch of height for every twelve inches of ramp. A rise of 24 inches needs 24 feet of ramp. This is the maximum slope the ADA allows for new construction, and it exists because steeper ramps are hard to climb in a manual chair and hard to control coming down.
The ADA applies to public buildings and businesses, not to private homes. Nobody is going to cite you for a steeper ramp on your own house. It is still the number to design to, because it reflects what a person can manage without help, and because a ramp that needs a second person defeats the point of installing one.
Steeper slopes have real uses. 2:12 is common where someone is always there to push, and 3:12 shows up on short portable ramps used to load an empty chair or scooter into a vehicle. Neither is safe for a person to self propel.
When you need a landing
A single run of ramp can climb 30 inches before it needs a level landing. Above that, the ramp is broken into runs with a flat resting platform between them, which is why tall porches end up with switchback ramps rather than one long diagonal.
Landings are also needed at the top and the bottom. The minimum is 60 inches long, and 60 by 60 inches where the ramp changes direction, so a chair can turn. Handrails are required on both sides of any run rising more than 6 inches, and the ramp surface should be at least 36 inches wide between them.
Questions people ask
Do I need a permit for a ramp at my house?
Often yes, particularly for anything permanent or attached to the structure. Rules vary by city and county, and some places waive the requirement for temporary or freestanding ramps. Check with your local building department before you buy materials, since a permit issue discovered later can mean removing the ramp.
Can I use a shorter ramp than the calculator says?
You can, and plenty of people do. Understand the trade. At 2:12 someone will need to push, and on the way down the chair will want to run. If the space genuinely will not take a 1:12 ramp, a switchback layout or relocating the ramp to a lower entrance usually beats accepting a steep slope.
What if I do not have room for a straight ramp?
Turn it. An L shape or a switchback fits the same total length into a fraction of the yard, at the cost of a 60 by 60 inch landing at each turn. Modular aluminum systems are designed for exactly this and can be reconfigured later.
Is a threshold ramp the same thing?
No. A threshold ramp handles a single lip, typically half an inch to six inches, at a doorway or between rooms. It is a wedge rather than a ramp run, and it does not need landings or handrails.
Will Medicare pay for a ramp?
Original Medicare does not cover home modifications such as ramps, because it treats them as a home improvement rather than durable medical equipment. Some Medicare Advantage plans, state Medicaid waiver programs, VA grants and local nonprofits do. See funding programs.
This calculator follows ADA Standards for Accessible Design, sections 405.2 through 405.8. It is a planning tool, not a substitute for a site survey or your local building code. For width, handrails, edge protection and every other rule, see the full ADA ramp requirements.